合 勤 zyxel 642-S路由器怎么映射端口。

发布于2022-01-12 18:23:57

合 勤 zyxel 642-S路由器怎么映射端口。我要详细过程。

1个回答
admin
网友回答2022-01-12
ZYXEL华勒合勤642端口映射Menu 11.1 - Remote Node Profile Rem Node Name= ChangeMe Route= IPActive= Yes Bridge= NoEncapsulation= PPPoE Edit PPP Options= NoMultiplexing= LLC-based Rem IP Addr= 0.0.0.0Incoming: Edit IP/IPX/Bridge= NoRem Login=Rem Password= ********Outgoing: Session Options:My Login= czz7205800@adsl Edit Filter Sets= NoMy Password= ******** PPPoE Idle Timeout(sec)= 0Authen= CHAP/PAP PPPoE Service Name=Schedule Sets=Press ENTER to Confirm or ESC to Cancel:注意在 Edit Filter Sets= No 空格键改为YES后,进入以下菜单:Menu 11.5 - Remote Node FilterInput Filter Sets:protocol filters=6device filters=Output Filter Sets:protocol filters=device filters=Call Filter Sets:protocol filters=device filters=Enter here to CONFIRM or ESC to CANCEL:将出现的 6 空格键去掉后回车存盘返回后 Edit Filter Sets= No 不要管它,回车存盘后设置15进15之后选2进去之后再选1Menu 15.2.1 - NAT Server Setup (Used for SUA Only)Rule Start Port No. End Port No. IP Address---------------------------------------------------1. 21 21 192.168.1.102. 4661 4669 192.168.1.10上面的例子1是把21端口映射到192.168.1.10例子2是把4661到4669的端口全部映射到192.168.1.10Rule Start Port No. End Port No. IP Address---------------------------------------------------1. Default Default 192.168.1.10这个是把所有端口全部都映射到192.168.1.10我的例子:Menu 15.2 - NAT Server SetupRule Start Port No. End Port No. IP Address---------------------------------------------------1. Default Default 0.0.0.02. 21 21 192.168.1.23. 80 80 192.168.1.24. 2300 2400 192.168.1.25. 47624 47624 192.168.1.26. 4661 4661 192.168.1.57. 4662 4662 192.168.1.58. 6881 6999 192.168.1.59. 0 0 0.0.0.010. 0 0 0.0.0.011. 0 0 0.0.0.012. 0 0 0.0.0.0Press ENTER to Confirm or ESC to Cancel:我的IP是192.168.1.5

回到
顶部